An Adaptive Approach in Polymer-Drug Nanoparticle Engineering using Slanted Electrohydrodynamic Needles and Horizontal Spraying Planes.

The present study focuses on the adaptive development of a key peripheral component of conventional electrohydrodynamic atomisation (EHDA) systems, namely spraying needles (also referred to as nozzles or spinnerets). Needle geometry and planar alignment are often overlooked. To explore potential impact, curcumin-loaded polylactic-co-glycolic acid (PLGA) and methoxypolyethylene glycol amine (PEG)-based nanoparticles were fabricated. To elucidate these technological aspects, a horizontal electrospraying needle regime was adapted, and three formulations containing different polymeric ratios of PLGA: PEG (50:50, 75:25, and 25:75) were prepared and utilised. Furthermore, processing head tip geometries e.g. blunt (a flat needle exit) or slanted (a 45° inclination angle), were subjected to various flow rates (5 µL-100 µL). Successful engineering of curcumin-loaded polymeric nanoparticles (< 150 nm) was observed. In-silico analysis demonstrated stable properties of curcumin, PEG and PLGA (molecular docking studies) and fluid flow direction towards the Taylor-Cone (also known as the stable jet mode), was shown by the assessment of fluid dynamics simulations in various needle outlets. Curcumin-loaded nanoparticles were characterised using an array of methods including Scanning electron microscopy, Differential scanning calorimetry, Fourier transform infrared spectroscopy, X-ray diffraction, as well as their contact angles, encapsulation efficiencies and finally release patterns. The discrepancy when spraying with blunt and angled needles was evidenced by electron micrographs and deposition patterns. Spraying plumes utilising slanted needles enhanced particle collection efficiency and distribution of resultant atomised structures. In addition to needle design, fine-tuning the applied voltage and flow rate impacted the electrospraying process. The coefficient of variation was calculated as 30.5% and 25.6% for blunt and angled needle outlets, respectively, presenting improved particle uniformity with the employment of angled needle tips (8-G needle at 25 µL). The interplay of processing parameters with the utilisation of a slanted exit at a capillary optimised the spray pattern and formation of desired nanoparticulates. These demonstrate great applicability for controlled deposition and up-scaling processes in the pharmaceutical industry. These advances elaborate on EHDA processes, indicating a more cost-effective and scalable approach for industrial applications, facilitating the generation of a diverse range of particle systems in a controlled and more uniform fashion.